Quatech AirborneDirect WLNG-ET Series Especificações descarregar pdf (Página 31)

2 – CLI Commands

100-8005-101G Airborne™ Product Family CLI Reference Guide Page 25

Quatech, Inc. Confidential

Command CLI Arguments Ln Description

wl-key-3 [aschex] L3* Sets WEP Key #3 to binary value.

[10 or 26 hex digits] – 10 digits for 64 bits, 26 for 128 bits.

Default is 00000000000000000000000000.

wl-key-4 <aschex> L3* Sets WEP Key #4 to binary value.

[10 or 26 hex digits] – 10 digits for 64 bits, 26 for 128 bits.

Default is 00000000000000000000000000.

wl-ant [string] L3*

Antenna Selection

1 = Ant1 (not currently supported)

2 = Ant2 (default)

d = enables receive diversity

wl-scan L2 Performs a scan for APs and reports status.

If [string] is specified, AP SSIDs that match the string are listed.

Partial matching SSIDs are listed when the * wildcard is appended to

string. For example, if APs have an SSID of Airborne™ 31 and the

SSID is Airborne™ *, the Module scans for APs that start with

Airborne™.

The status report for each found AP is as follows (for a description of

these results, see Table 2):

SSID: FirstAccessPoint

BSSID: 0006255D537D

signal (dBm): -56

rate (Mb/s): 0x0014

capabilities: 0x0005

channel: 0x0007

beacon interval: 100

---------------------

SSID: SecondAccessPoint

BSSID: 0006255D5C2C

signal (dBm): -55

rate (Mb/s): 0x000A

capabilities: 0x0015

channel: 0x0008

beacon interval: 100

---------------------

wl-rate [string] L3 Configures the maximum wireless data rate for the Module (in

Mbps). For rates above 1 Mbps, the Module may fall back to a

lower rate. Lower data rates may result in better range.

0 = auto (selects best highest rate - default)

1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, or 54

wl-device L1 Reports the DPAC-defined Module device type. This may be used

by an OEM application to identify the type of device that it is

communicating with. The current list of device types reported is:

AIRBORNE™

AIRBORNE™ -SPI

DIRECT-ETHERNET

DIRECT-SERIAL

wl-region [string] L3 Specifies the wireless channels allowed. See table 3 for allowed

values.

Default is US.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Comentários a estes Manuais

Sem comentários

Quatech AirborneDirect WLNG-ET Series Especificações Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Quatech AirborneDirect WLNG-ET Series