Quatech SPP-100 Manual do Utilizador descarregar pdf (Página 15)

Waddress specifies the base address of the memory window required to configure the

SSP-100. Set address = D0 for a memory window at segment D000, address

D8 for a memory window at segment D800, etc. Valid settings for address

are C8, CC, D0, D4, D8, and DC. If this option is omitted, a memory

window at segment D000 will be used.

Cclock specifies the multiple of the standard frequency for the UART clock. Valid

values for clock are 1 or 8. A value of 1 yields a clock frequency of 1.8432

MHz; a value of 8 yields 14.7456 MHz. If this option is omitted, the

standard clock frequency will be used.

Before removing a SSP-100 from its PCMCIA socket, the Enabler should be executed to

free the system resources allocated when the card was installed. For this operation the

Enabler provides on additional command line option:

R instructs the enabler to release the resources previously allocated to the

SSP-100. When the 'R' option is used, any settings specified by the 'B' and 'I'

options are ignored.

2.2.1.1 Example 1

SSP130EN.EXE

In example 1, no command line argument is specified. The Enabler will report an error

and display the proper usage of the command.

2.2.1.2 Example 2

SSP130EN.EXE (s0,b300,i5)

In example 2, the Enabler will configure the SSP-100 in socket 0 with a base address of

300H and IRQ 5 using a configuration memory window at segment D000.

2.2.1.3 Example 3

SSP130EN.EXE (i10,h,b340,s1)

In example 3, the Enabler will configure the SSP-100 in socket 1 with a base address of

340H and IRQ 10 using a configuration memory window at segment D000.

2.2.1.4 Example 4

SSP130EN.EXE (s0,b300,i3,wd8)

In example 4, the Enabler will configure the SSP-100 in socket 0 with a base address of

300H and IRQ 3 using a configuration memory window at segment D800.

DOS/Windows 3.x 2-10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sem comentários

Quatech SPP-100 Manual do Utilizador Página 15